Mack Super Liner


        
Listing Media Listing Media

This ad has been sold. Please view similar ads below or start a new search by clicking buy.

All
Photos
Videos

Request a Quote

Request a no obligation, free quote on this product from your choice of dealers.

  • Engine: Mack MP10 16 litre, 600Hp – 685Hp (Ref Engine chart), Selective Catalytic Reduction (SCR), Emission Level Euro5 (ADR80-03)
    Fan: Behr Visco drive (electric over viscous fan clutch), 813mm (32”) 11-blade nylon fan
    Radiator: NL1, Frontal area 1,757in²
    Exhaust: Single RHS frame mounted catalyst with stainless steel heat shield, Outlet twin 152mm (6”) vertical exhaust (Day Cab & Sleeper Cab), Exhaust tip height above ground 3.5mtr, Exhaust tip height above ground 4.2mtr (optional)
    Air Intake & Filter: Donaldson 279mm (11”) single dry type element, dual canisters mounted under the cab, Painted steel dust extractors and external raised air intakes mounted in front of the cabin ‘A’ pillars
    Filters: 2 full flow and 1 bypass engine mounted oil filters, 2 step dual engine mounted fuel filters / water separator
    Air Compressor: Twin cyl 900 litres/min WABCO compressor
  • Type: Eaton 394mm (15.5”) Easy Pedal with VCT Plus, Eaton ‘SOLO’ with VCT Plus (optional), Air assist clutch release, SACHS 430mm (17”) Single Plate (mDRIVE only)
  • Transmission: Automated Manual and Manual Transmissions (Ref Transmission chart), Transmission oil cooler (optional)
    Make: Mack (mDrive)
    Model: ATO3112D
    Max Torque: 2,350ft–lbs
    FWD Gears: 12
    Rev Gears: 2
    LO/HI: 11.73 / 0.78
    Type: Automated Manual
    Make: Eaton
    Model: RTLO-22918B (optional)
    Max Torque: 2,250ft-lbs (600Hp only)
    FWD Gears: 18
    REV Gears: 4
    LO/HI: 14.40/0.73
    Type: Manual
    PTO Provision: mDRIVE transmission mounted – DIN or Flange (optional), Rear of engine (PTO) – CA, Prep kit, switch, wiring and software (mDRIVE) (optional)
  • Front Axle: Mack FXL with unitised hubs (Refer Steer Axle Chart), Axle position: Mid Axle Forward: 1,058mm Bumper Front Axle
    Steer Axle: Make: Mack
    Model: FXL 14.6
    Capacity: 14,600lbs (6.6t)
    Suspension*: CLX (P3, M8)
    Make: Mack
    Model: FXL 16.5
    Capacity: 16,500lbs (7.5t)
    Suspension*: CLX (P3,M8) (optional)
    * Note: Parabolic Standard Duty (P), Multileaf Standard Duty (M) – Number = Leaf Qty
  • Rear Axles: Mack, Meritor and Dana axle options (Refer Drive Axle Chart), Ratings 21 to 24 tonne
    Drive Axle: Make: Mack
    Model: S462
    Capacity: 46,000lbs (21t)
    Ratios: 3.63, 3.94, 4.35
    Suspension: AD246 / CAMELBACK
    Make: Meritor
    Model: RT46-160
    Capacity: 46,000lbs (21t)
    Ratios: 3.42, 3.58, 3.73, 3.91, 4.10, 4.30
    Suspension: AP460 / AD246/MIL-H
    Make: Meritor
    Model: RT52-185
    Capacity: 52,000lbs (24t)
    Ratios: 3.58, 3.73, 4.10, 4.30
    Suspension: MIL-X
    Make: Meritor
    Model: RT50-170
    Capacity: 50,000lbs (23t)
    Ratios: 3.42, 3.58, 3.73, 3.91, 4.10, 4.30
    Suspension: AP460
    Make: Dana
    Model: D50-170
    Capacity:50,000lbs (23t)
    Ratios: 3.58, 3.73, 3.91, 4.10, 4.30
    Suspension: AD246
    *Note: Other ratios available via Customer Adaptation request
  • Inter-axle/Wheel Locks: DCDL one axle only (vendor axles only), DCDL’s on both axles (optional), Mack Power Divider (standard with Mack axles)
  • Front Suspension: 1,321mm (52”) long springs (Refer Steer Axle Chart)
  • Rear Suspension: Air and mechanical spring options (Refer Drive Axle Chart), Ratings 19 to 24 tonne
  • Brakes: Front automatic slack adjusters, Type 20 (FXL 14.6) Type 24 (FXL 16.5) brake boosters, S’ Cam with centrifuse drums (optional), Rear automatic slack adjusters, Type 30/30 brake boosters, S’ Cam with cast iron drums
    Low tare alloy hubs (optional), ABS or (optional) ABS with Traction Control, Grade Gripper - hill start assist (standard with mDrive), Road Stability Advantage (ESP - Electronic Stability Program)– optional,
    Engine Break: Advanced PowerLeash engine brake, Engine retarding power up to 570Hp (425kW)
  • Steering Gear: Sheppard SD110, Steering ratio 16.9:1, Steering damper
  • Wheels: 10-stud 8¼” (285mm PCD) steel disc, 10-stud options: 8¼” (285mm PCD) machine buff disc, 8¼” (285mm PCD) DURABRIGHT alloy disc, 9” (285mm PCD) polished or DURABRIGHT alloy disc
    Tyres: Bridgestone / Michelin tyres
    Tyre Equipment: Wheel lug wrench kit, Bottle jack (optional)
  • Specs: 26” round polished alloy tanks, Large capacity polished D-shaped tanks (optional), Stainless Steel D tank straps (CA), AdBlue Tank, kerbside (LHS) location, 125 litre stainless steel 26” round, 150 litre stainless steel 26” round or D-shaped (optional)
  • Chassis: Advantage 300mm x 90mm x 8mm, 156,000psi/RBM 1,940,000in lb
    Advantage 300mm x 90mm x 9.5mm, 184,000psi/RBM 2,240,000in lb
    Advantage 300mm x 90mm x 11.1mm, 212,000psi/RBM 2,590,000in lb
    Afterframe: 1,460mm (57.5”) to 1,550mm (61”)
    All chassis lengths come with tapered rail ends
    Cab Support: Front: Two metalistic pivot mounts
    Rear: Air isolation with dual shock absorbers
    Fully suspended cab
    Rear panard rod
    Bullbar/ Bumper/ FUPS: Light weight alloy bumper with front underrun protection
    Heavy duty bullbar with front underrun protection (optional)
    Temporary Transit FUP device (Option)
    Chassis Access Step: Staired and perforated 2 step design (optional)
  • Batteries: Four 12volt Bulldog batteries, high capacity (620 CCA), LH and RH frame mounted with black battery box cover, Polished aluminium battery box cover (optional), Batteries mounted in sleeper if fitted, Stacked battery box (CA)
    Alternator: Leece Neville 12volt/160Amp Brushed, Leece Neville 12volt/160Amp Brushless (optional), Leece Neville 12volt/185Amp Brushless (optional), Leece Neville 12volt/200Amp Brushed (optional)
    Starter: MELCO 12volt electric starter
    Key type start and stop
    Electrical: Chassis harness with protective conduit
    Electrical prep kit, Body Builder chassis connections (optional)
    Courtesy Lamps: Drivers/Passengers door entry lighting, Ambient floor lighting
    Headlamps: Hella integral light/indicator unit with polycarbonate lens
    Marker & Tail Lamps: 5 roof-mounted amber lights and 3 in 1 tail lamp
    LED roof clearance and tail lamps (optional)
    Reversing Alarm: Chassis mounted back up alarm (optional)
    Warning Beacon: Single amber revolving roof beacon (optional)
    Double amber revolving roof beacons (optional)
    Double amber revolving beacons air intake mounted (optional)
    Hook Up Lamp: Rear of cab mounted hook up lamp (optional)
  • Wheelbase: 5,250mm (206”) to 6,265mm (246”)
  • Air Dryer:
    Bendix AD-IS air dryer
    Remote Breathers:
    Transmission, fuel and axle remote breather kit (optional)
    Trailer Connections:
    Trailer - connections back of cab
    Trailer - connections back of cab and rear of frame (optional)
    Air: Service and emergency with blanking plugs
    Electrical: 12volt 7-pin female base with HD 5mm² cabling
    Telematics:
    Mack telematics system - speak with your Authorised Dealer for further information.
    Shell:
    Fusion Cab, ECE29 (cab strength test) compliant, Two piece windscreen
    Sleeper Options:
    710mm (28”) Super Cab with rear cabin extension
    762mm (30”) High (CA) 3 Door
    915mm (36”) High-rise premium sleeper – 3 door (CA)
    1,015mm (40”) Mid-rise premium sleeper – 4 door
    1,170mm (46”) Mid-rise premium sleeper – 4 door
    1,170mm (46”) High-rise premium sleeper – 4 door
    1,320mm (52”) Mid-rise premium sleeper – 4 door
    1,320mm (52”) High-rise premium sleeper – 4 door
    1473mm (58”) and 1829mm (72”) High available (CA)
    All sleepers have 4 access door and vertical cab extenders
    * Note additional sleeper options are available, speak with your Authorised Dealer.
    Cab Interior:
    Overhead storage (up to 3 pockets based on cab configuration), Rear Wall storage available (based on cab configuration), Door Storage (2 pockets), Cup Holders in dash, Centre storage console (available based on cab configuration), Interior Trim - pleated ultra leather or diamond plate, Central locking available, Power windows available, Self cancelling signals available (optional), Internal grab handles, Speak with your Authorised Dealer for all options
    Seats:
    Driver: ISRI ‘Big-Boy’ air-ride Premium: ‘MACK’ embossed cloth trim, LH arm rest, upper, side and lower lumbar support with oscillating base and fore/aft seat cushion adjustment
    Driver: ISRI ‘Big-Boy’ air-ride (optional): cloth trim, upper, side and lower lumbar support with fore/aft seat cushion adjustment
    Passenger: ISRI fixed cushion
    Passenger: ISRI premium air ride seat with upper and lower lumbar support, and fore/aft seat cushion adjustment (optional)
    Steering Wheel:
    Bulldog soft touch rubber grip 457mm (18”) diameter, Elite leather grip steering wheel (optional)
    Adjustable tilt and telescopic steering column
    Instrument:
    Driver information display – Co-Pilot, Speedometer/odometer (electronic), Tachometer/hourmeter (electronic), Voltmeter, engine hours, distance, trip recording, Engine coolant temperature, fuel and AdBlue levels, Primary and secondary air pressure, Oil pressure and oil temperature
    Full Gauge Package:
    Manifold pressure, transmission temperature, exhaust temperature, brake application pressure, front and rear drive axle temperature
    Windscreen Wipers:
    Electronic variable-speed, intermittent wipers with washer, Reservoir mounted under bonnet
    Audio System:
    Premium Radio/CD player including Bluetooth, iPod connector and USB connector
    Communications:
    GME CB radio (optional), GME UHF radio (optional)
    Climate Control:
    HVAC integral cab air conditioner/heater, Electronic controls, Replaceable dust intrusion filter
    Safety & Warning:
    Set of 3 safety warning triangles, Door mounted emergency procedure guide (optional), Emergency eye wash bottle (optional), 2.5kg in cab mounted fire extinguisher (optional), Fresnel Lens (optional)
    Cab Exterior:
    Fibreglass bonnet and polyfibre fenders with splash aprons, Bonnet tilts forward with spring assist, Chrome Grille surround and side air intakes, Polished stainless steel cab skirts and air intake tubes, Black nylon bonnet hold down straps, Bright finish bonnet hold down straps (optional), Stainless bug screen integrated with grille, Painted external sunvisor, Stainless steel exterior sunvisor (optional)
    Horns:
    2 x roof mounted, air horn trumpets, 2 x under bonnet mounted, electric
    Mirrors:
    Heated ‘West Coast’ mirrors with stainless steel arms, LH and RH power mirrors (standard), LH and RH 7” spotter mirrors (standard), LH down mirror (optional)
    Windscreen Stone Guard:
    Matt black mesh windscreen stone guard (optional)
    Paint Type & Colour:
    Cab/sleeper: Single non-metallic cab colour (Incredible white standard), Chassis: Single non-metallic chassis colour (black standard), Epoxy Mine specification primer (CA)
    Accessories:
    Many factory fitted accessories which are not listed, are also available, All customers are encouraged to see their Authorised Dealer for full details
    * Subject to conditions:
    Refer to your authorised Mack Dealer for:
    Detailed information
    Full Warranty details and limitations.
    Further details regarding the mass of options.
    The latest details on specifications, options, prices and availability

Request Quote

You might be interested in...